The material isn’t cutting correctly. Water sprays everywhere but the garnet is flowing.

This may be one of a few different issues.

• The material type is set incorrectly. Check the material settings. Adjust the settings as necessary.
• The material thickness setting is too low. Measure the material. Compare the measurement with the material setting. Adjust the setting as necessary.
• You try to cut too quickly. This problem occurs only with very thick material and low-quality settings. Contact a member of technical staff to adjust the garnet flow or the machinability grade of the material, or increase the material thickness setting a small amount.
• There is a blockage in the abrasive solenoid. This decreases the abrasive flow rate. Contact a member of technical staff, they will show you how to clean it.