Troubleshooting (OMAX Maxiem 1515): Difference between revisions

Troubleshooting (OMAX Maxiem 1515) (view source)

644 bytes added , 9 August 2024

639

edits

@@ Line 59: / Line 59: @@
 * You are trying to cut too quickly. This occurs very rarely with very thick material and very low quality settings. Ask a member of technical staff for help adjusting the garnet flow or the machinability grade of the material.
 * There's a clog in the abrasive solenoid which is reducing the abrasive flow rate. Ask a member of technical staff to show you how to unclog it.
+=== Water is going up the abrasive feed hose instead of out of the nozzle. ===
+If the nozzle is definitely not touching the material and blocking the water flow this way it's likely you have a clogged nozzle. The nozzle will need to be inverted in the nozzle body and the high pressure water test run to clean it out. Don't do this yourself, ask a member of technical staff for help.
+If the clog is particularly stubborn and won't come free with a simple high pressure test you may need to run the 100-cycle sample file available in the OMAX software. This will turn the pump on and off 100 times in an attempt to dislodge any contaminants.