639
edits
Troubleshooting (OMAX Maxiem 1515): Difference between revisions
Troubleshooting (OMAX Maxiem 1515) (view source)
Revision as of 16:10, 4 January 2024
, 4 January 2024Undo revision 711 by A.Dunbar (talk)
No edit summary Tags: Reverted Visual edit |
Tag: Undo |
||
| Line 38: | Line 38: | ||
=== The high pressure pump only runs for a few seconds before the VFD faults. === | === The high pressure pump only runs for a few seconds before the VFD faults. === | ||
This is probably a filter issue as well. See above. | This is probably a filter issue as well. See above. | ||
== Operation & Movement Problems == | |||
=== The machine doesn't want to move anymore. There doesn't appear to be any errors, it just won't jog anywhere or start a job. === | |||
Check the transparent-fronted safety box on the side of the tank, next to the PC trolley. There is a small rocker switch on the side that sometimes gets knocked - this should be in the "on" position. Press the blue button once it's in the right position, then press the black button on the machine pendant. | |||
=== The Z-axis makes an awful creaking noise when it moves. === | |||
It shouldn't! Ask a member of technical staff to look at cleaning and greasing the rails and lead screw ahead of the recommended maintenance schedule. | |||
== Cutting Problems == | |||
=== The material isn't cutting and water is spraying everywhere. === | |||
Check that garnet is flowing freely through the abrasive delivery hose. If there is moisture in the hose it must be cleaned out. Occassionally water makes its way into the tool head garnet hopper. In this case the abrasive solenoid and the hopper must be cleaned. Ask a member of technical staff for help with this. | |||
=== The material isn't cutting properly - water is spraying everywhere but the garnet is definitely flowing. === | |||
This may be one (or many) of a few different issues. | |||
* The material type is set incorrectly. Check the material settings and adjust as needed. | |||
* The material thickness is set too thin. Measure the material and compare with the material setting. Adjust as needed. | |||
* You are trying to cut too quickly. This occurs very rarely with very thick material and very low quality settings. Ask a member of technical staff for help adjusting the garnet flow or the machinability grade of the material. | |||
* There's a clog in the abrasive solenoid which is reducing the abrasive flow rate. Ask a member of technical staff to show you how to unclog it. | |||