Power Up and Power Down (Laser Cutters)

From Make In Salford
Revision as of 12:27, 29 December 2023 by A.Dunbar (talk | contribs) (Created page with "== Power Up == === Epilog Fusion Pro 48 === * Turn on the centrally controlled laser cutter fume extraction system. * Check the emergency stop button is not pressed by turning in the direction of the arrow. * Close the lid of the laser cutter. * Turn the key switch marked "Power" to the on position. * Wait for the machine display screen to load fully and for the machine to finish its homing cycle before opening the lid. === Gravograph LS900 === * Turn on the centrall...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Power Up

Epilog Fusion Pro 48

  • Turn on the centrally controlled laser cutter fume extraction system.
  • Check the emergency stop button is not pressed by turning in the direction of the arrow.
  • Close the lid of the laser cutter.
  • Turn the key switch marked "Power" to the on position.
  • Wait for the machine display screen to load fully and for the machine to finish its homing cycle before opening the lid.

Gravograph LS900

  • Turn on the centrally controlled laser cutter fume extraction system.
  • Make sure the lid is closed.
  • Turn on the power switch on the right hand side of the body of the laser cutter body.
  • Wait for the machine display screen to load fully and display "Ready to receive" before opening the lid.

Power Down

  • Remove all material from the laser cutter. Snap spindly remnants and place on back on the shelf.
  • Clean small remnants from the trays underneath the slat bed.
  • Turn off the power switch on the machine, and any air compressors you may be using.
  • If there are no other laser cutters in use you may turn off the fume extraction.
Retrieved from "https://www.makeinsalford.com/wiki/index.php?title=Power_Up_and_Power_Down_(Laser_Cutters)&oldid=660"