Power Up and Power Down (Laser Cutters): Difference between revisions
(Created page with "== Power Up == === Epilog Fusion Pro 48 === * Turn on the centrally controlled laser cutter fume extraction system. * Check the emergency stop button is not pressed by turning in the direction of the arrow. * Close the lid of the laser cutter. * Turn the key switch marked "Power" to the on position. * Wait for the machine display screen to load fully and for the machine to finish its homing cycle before opening the lid. === Gravograph LS900 === * Turn on the centrall...") |
No edit summary |
||
| Line 1: | Line 1: | ||
== Power Up == | == Power Up == | ||
[[File:Laser-cutter-extraction-switch.jpg|thumb|Centrally controlled fume extraction switch, located opposite the Technician's Office. ]] | |||
=== Epilog Fusion Pro 48 === | === Epilog Fusion Pro 48 === | ||
Latest revision as of 12:30, 29 December 2023
Power Up
Epilog Fusion Pro 48
- Turn on the centrally controlled laser cutter fume extraction system.
- Check the emergency stop button is not pressed by turning in the direction of the arrow.
- Close the lid of the laser cutter.
- Turn the key switch marked "Power" to the on position.
- Wait for the machine display screen to load fully and for the machine to finish its homing cycle before opening the lid.
Gravograph LS900
- Turn on the centrally controlled laser cutter fume extraction system.
- Make sure the lid is closed.
- Turn on the power switch on the right hand side of the body of the laser cutter body.
- Wait for the machine display screen to load fully and display "Ready to receive" before opening the lid.
Power Down
- Remove all material from the laser cutter. Snap spindly remnants and place on back on the shelf.
- Clean small remnants from the trays underneath the slat bed.
- Turn off the power switch on the machine, and any air compressors you may be using.
- If there are no other laser cutters in use you may turn off the fume extraction.