Power Up and Power Down (Laser Cutters): Difference between revisions
No edit summary |
No edit summary |
||
| Line 10: | Line 10: | ||
* Wait for the machine display screen to load fully and for the machine to finish its homing cycle before opening the lid. | * Wait for the machine display screen to load fully and for the machine to finish its homing cycle before opening the lid. | ||
=== | === Epilog Fusion Pro 36 === | ||
* Turn on the centrally controlled laser cutter fume extraction system. | * Turn on the centrally controlled laser cutter fume extraction system. | ||
* Turn on the power switch on the top right hand side of the body of the laser cutter body. | |||
* Turn on the power switch on the right hand side of the body of the laser cutter body. | * Wait for the machine display screen to load fully and for the machine to finish its homing cycle before opening the lid. | ||
* Wait for the machine display screen to load fully and | |||
== Power Down == | == Power Down == | ||
| Line 21: | Line 20: | ||
* Remove all material from the laser cutter. Snap spindly remnants and place on back on the shelf. | * Remove all material from the laser cutter. Snap spindly remnants and place on back on the shelf. | ||
* Clean small remnants from the trays underneath the slat bed. | * Clean small remnants from the trays underneath the slat bed. | ||
* Turn off the power switch on the machine | * Turn off the power switch on the machine. | ||
* If there are no other laser cutters in use you may turn off the fume extraction. | * If there are no other laser cutters in use you may turn off the fume extraction. | ||
[[Category:Power Up and Power Down]] | [[Category:Power Up and Power Down]] | ||
[[Category:Laser Cutter]] | [[Category:Laser Cutter]] | ||
Latest revision as of 09:41, 2 April 2025
Power Up
Epilog Fusion Pro 48
- Turn on the centrally controlled laser cutter fume extraction system.
- Check the emergency stop button is not pressed by turning in the direction of the arrow.
- Close the lid of the laser cutter.
- Turn the key switch marked "Power" to the on position.
- Wait for the machine display screen to load fully and for the machine to finish its homing cycle before opening the lid.
Epilog Fusion Pro 36
- Turn on the centrally controlled laser cutter fume extraction system.
- Turn on the power switch on the top right hand side of the body of the laser cutter body.
- Wait for the machine display screen to load fully and for the machine to finish its homing cycle before opening the lid.
Power Down
- Remove all material from the laser cutter. Snap spindly remnants and place on back on the shelf.
- Clean small remnants from the trays underneath the slat bed.
- Turn off the power switch on the machine.
- If there are no other laser cutters in use you may turn off the fume extraction.