Page history
23 October 2024
7 February 2024
23 January 2024
→More Information
+35
no edit summary
+146
Created page with "Inserts and tools used in the lathe wear gradually and relatively predictably. In order to hold tight tolerances on the machine you can offset the tool a small amount to account for the minute wear of the inserts before it is time to replace them. We'll only cover static turning tools here. == Turning Tool Offsets == Access the tool offsets page by pressing '''OFFSETS''' on the lathe control panel. Press F4 if required to switch to the tool offsets page. You should..."
+1,083