Power Up and Power Down (Laser Cutters): Difference between revisions

Power Up and Power Down (Laser Cutters) (view source)

53 bytes removed , 2 April

no edit summary

682

edits

@@ Line 10: / Line 10: @@
 * Wait for the machine display screen to load fully and for the machine to finish its homing cycle before opening the lid.
-=== Gravograph LS900 ===
+=== Epilog Fusion Pro 36 ===
 * Turn on the centrally controlled laser cutter fume extraction system.
-* Make sure the lid is closed.
+* Turn on the power switch on the top right hand side of the body of the laser cutter body.
-* Turn on the power switch on the right hand side of the body of the laser cutter body.
+* Wait for the machine display screen to load fully and for the machine to finish its homing cycle before opening the lid.
-* Wait for the machine display screen to load fully and display "Ready to receive" before opening the lid.
 == Power Down ==
@@ Line 21: / Line 20: @@
 * Remove all material from the laser cutter. Snap spindly remnants and place on back on the shelf.
 * Clean small remnants from the trays underneath the slat bed.
-* Turn off the power switch on the machine, and any air compressors you may be using.
+* Turn off the power switch on the machine.
 * If there are no other laser cutters in use you may turn off the fume extraction.
 [[Category:Power Up and Power Down]]
 [[Category:Laser Cutter]]