COSHH - Cutwel - Bacteriacide Ultra
Storage Location
COSHH Cabinet - Morson Engine Room
Return this item to its storage place once you have finished using it. If it is empty, please let a member of technical staff know so more can be ordered.
Manufacturer's Information
Personal Protective Equipment
|
Nitrile Gloves You must wear nitrile gloves when using this chemical. |
|
Safety Glasses You must wear safety glasses when using this chemical. |
|
Visor may be required If there is a risk of splashing a face shield or visor may be required. |
Hazards
|
Keep out of reach of children |
|
May cause an allergic skin reaction Wear protective gloves when using this chemical, and other protective clothing if the circumstances require it. Prevent contact with skin, and wash immediately with plenty of soap and water in the event of contact. |
|
|
Harmful if swallowed |
Usage Information
- The use of this coolant additive is controlled and should only be used when the coolant management process indicates it is a requirement.
- For a "shock" dose of a highly contaminated metalworking fluid use the following formula: Coolant Tank Volume x 0.5% = ml/litre.
- For a maintenance "controlling" dose use the following formula: Coolant Tank Volume x 0.2% = ml/litre.
- Add the fluid to the coolant at a point of high turbulence and circulate for at least 30 minutes to ensure it is mixed into the metalworking fluid properly.
- If this additive is being used on the UMC-500 ensure that the through-spindle coolant pump is run for at least 30 minutes in addition and separetely to to the normal coolant pump.
Dosage Amounts
- Shock dose for the UMC-500, full coolant tank: 217 ml
- Controlling dose for the UMC-500, full coolant tank: 87 ml
- Shock dose for the ST-15Y, full coolant tank: 65 ml
- Controlling dose for the ST-15Y, full coolant tank: 26 ml