Haas UMC-500
|
This is a restricted use machine. You must be specifically trained before using this equipment. Review the self-directed learning information on this page and book in for in-person training with a member of technical staff. |
|
|
Missing Safety Information This machine or process is currently missing safety information. Please make sure you check the risk assessments and datasheets in person - ask a member of technical staff if you are unsure. |
 | This placeholder article needs more information adding to it. More details are coming soon, if you can please ask the technical staff for a wiki account and help out. |
 | |
| 5-axis CNC milling machine located in the Morson Engine Room. | |
| Equipment Information | |
|---|---|
| Status | Unknown |
| Manufacturer | Haas |
| Model | UMC-500 |
| Working Area | 400 mm ⌀ x 250mm |
| Maker Space Information | |
| Training Required | Yes |
| Training Information | Here |
The Haas UMC-500 is a powerful piece of computer controlled equipment, capable of accurately cutting both ferrous and non-ferrous metals as well as an assortment of plastics and dense modelling foams. It uses a spinning cutting tool such as an endmill or drill to remove material from the parent stock, leaving the finished part at the end. It is a subtractive machine tool. For examples of parts that have been made on this machine take a look at the Portfolio/Gallery page on this Wiki.
Training
We have produced a series of training parts which will teach you a variety of CAM programming techniques. Follow the instructions on the training page for this machine, and then book an in-person training session through the online booking form.
Once you have completed the first part you are welcome to use the machine independently to complete the remaining components in the set. Once the set is complete, you can use the machine unsupervised. The Maker Space technical staff can assist with any questions you have.
Power Up & Power Down
Power Up & Power Down (Haas UMC-500)
You must warm up the spindle bearings if the machine has not been used in the last 24 hours. This is to ensure they are properly lubricated and ready for high loads.
5-axes
Typical vertical CNC mills can work in three axes: Z, up and down; X, left to right; and Y, front to back. This 5-axis machine adds two rotary axes, B and C, to allow access to five out of six sides of a cube in one setup - that is without taking the workpiece out and repositioning it in the machine. This allows much faster prototyping and faster turnaround times for one off parts.
Workholding
There is a range of workholding solutions available for you to use, all centering around the quick-change 5th Axis Rocklock Base. This base uses pull studs on a 96mm square pattern to allow rapid workholding changes. It is possible to machine your own fixtures using the 96mm pattern and the proprietary pull studs.
More information, including guidance for using each of the available vises, is available on the Workholding page.
Tools & Toolholders
We try to provide a standard set of tools ready to use in the machine. These tools are found in the Fusion 360 tool library, and are kept set up in their tool holders either in the machine or in the tool cabinet.
The toolholders are also somewhat standard, with noted exceptions for special use tools.