Warming up the spindle (AXYZ Innovator)

From Make In Salford
Revision as of 10:48, 3 February 2025 by A.Dunbar (talk | contribs) (Created page with "The spindle of this machine is a high-speed variety and must be warmed up before starting work. A warmup cycle is prompted when the machine is turned on, but should be performed again if it has sat unused for more than an hour. == Running a manual spindle warmup cycle == * Remove any tool that's in the spindle either manually using the release button or using the tool change function codes. The warmup cycle should not be run with a tool in the spindle. * Clear the sa...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

The spindle of this machine is a high-speed variety and must be warmed up before starting work. A warmup cycle is prompted when the machine is turned on, but should be performed again if it has sat unused for more than an hour.

Running a manual spindle warmup cycle

  • Remove any tool that's in the spindle either manually using the release button or using the tool change function codes. The warmup cycle should not be run with a tool in the spindle.
  • Clear the safety mat and turn the reset key.
  • Type F 39 and press Enter.
  • The spindle will now ramp up in speed over the course of 6 minutes.
Retrieved from "https://www.makeinsalford.com/wiki/index.php?title=Warming_up_the_spindle_(AXYZ_Innovator)&oldid=1306"