Probing tool length (AXYZ Innovator)

From Make In Salford
Revision as of 11:57, 20 January 2025 by A.Dunbar (talk | contribs) (Created page with "You must probe each of the tools every time you come to use the machine - do not assume that the tools in the rack have been set correctly. == Probing tool length automatically == * Turn on the machine and warm up the spindle. If the machine has been sat for more than an hour or two it's recommended you warm up the spindle again. * Remove the cover from the tool probe. * Clear the safety mat and turn the reset key. * Type '''F 25.''n''''' and press '''Enter''', where '...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

You must probe each of the tools every time you come to use the machine - do not assume that the tools in the rack have been set correctly.

Probing tool length automatically

  • Turn on the machine and warm up the spindle. If the machine has been sat for more than an hour or two it's recommended you warm up the spindle again.
  • Remove the cover from the tool probe.
  • Clear the safety mat and turn the reset key.
  • Type F 25.n and press Enter, where n is the tool pocket you wish to probe.
  • The machine will now pick up the tool as needed and travel to the tool probe location. Press Enter to start the probing cycle.
  • Once the probing cycle has completed the machine will return to where it was when you started the process.
Retrieved from "https://www.makeinsalford.com/wiki/index.php?title=Probing_tool_length_(AXYZ_Innovator)&oldid=1300"