640
edits
Troubleshooting (Haas ST-15Y): Difference between revisions
Troubleshooting (Haas ST-15Y) (view source)
Revision as of 18:40, 15 December 2023
, 15 December 2023no edit summary
No edit summary |
No edit summary |
||
| Line 6: | Line 6: | ||
Drilling with one of the live tool spindles is usually a waste of time because the main spindle is much more powerful. Only use the live tool spindle if you need to drill off-axis. | Drilling with one of the live tool spindles is usually a waste of time because the main spindle is much more powerful. Only use the live tool spindle if you need to drill off-axis. | ||
== Workholding Problems == | |||
=== The program won't start because it says the spindle is unclamped, but it definitely is. === | |||
The workholding may have recently been changed. Check the value of Setting 282. | |||
When you are using the [[Klamp DKF65A6|collet chuck]] Setting 282 must be set to "OD". When you are using the [[Hydraulic 3-Jaw Chuck|hydraulic 3-jaw chuck]] it should be set to "ID". | |||
[[Category:CNC Machinery]] | [[Category:CNC Machinery]] | ||
[[Category:Fusion 360]] | [[Category:Fusion 360]] | ||
[[Category:Lathe]] | [[Category:Lathe]] | ||