Warming up the spindle (AXYZ Innovator): Difference between revisions
(Created page with "The spindle of this machine is a high-speed variety and must be warmed up before starting work. A warmup cycle is prompted when the machine is turned on, but should be performed again if it has sat unused for more than an hour. == Running a manual spindle warmup cycle == * Remove any tool that's in the spindle either manually using the release button or using the tool change function codes. The warmup cycle should not be run with a tool in the spindle. * Clear the sa...") |
No edit summary |
||
| Line 1: | Line 1: | ||
The spindle of this machine is a high-speed variety and must be warmed up before starting work. A warmup cycle is prompted when the machine is turned on, but should be performed again if it has sat unused for more than | The spindle of this machine is a high-speed variety and must be warmed up before starting work. A warmup cycle is prompted when the machine is turned on, but should be performed again if it has sat unused for more than two hours. | ||
== Running a manual spindle warmup cycle == | == Running a manual spindle warmup cycle == | ||
Revision as of 10:50, 3 February 2025
The spindle of this machine is a high-speed variety and must be warmed up before starting work. A warmup cycle is prompted when the machine is turned on, but should be performed again if it has sat unused for more than two hours.
Running a manual spindle warmup cycle
- Remove any tool that's in the spindle either manually using the release button or using the tool change function codes. The warmup cycle should not be run with a tool in the spindle.
- Clear the safety mat and turn the reset key.
- Type F 39 and press Enter.
- The spindle will now ramp up in speed over the course of 6 minutes.