Warming up the spindle (AXYZ Innovator): Difference between revisions
(Created page with "The spindle of this machine is a high-speed variety and must be warmed up before starting work. A warmup cycle is prompted when the machine is turned on, but should be performed again if it has sat unused for more than an hour. == Running a manual spindle warmup cycle == * Remove any tool that's in the spindle either manually using the release button or using the tool change function codes. The warmup cycle should not be run with a tool in the spindle. * Clear the sa...") |
No edit summary |
||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
The spindle of this machine is a high-speed variety and must be warmed up before starting work. A warmup cycle is prompted when the machine is turned on, but should be performed again if it has sat unused for more than | The spindle of this machine is a high-speed variety and must be warmed up before starting work. A warmup cycle is prompted when the machine is turned on, but should be performed again if it has sat unused for more than two hours. | ||
== Running a manual spindle warmup cycle == | == Running a manual spindle warmup cycle == | ||
* Remove any tool that's in the spindle either manually using the release button or using the tool change function codes. The warmup cycle should not be run with a tool in the spindle. | * Remove any tool that's in the spindle either manually using the release button or using the tool change function codes. The warmup cycle should not be run with a tool in the spindle. | ||
* Clear the safety mat and turn the | * Clear the safety mat and turn the '''SAFETY RESET''' key. | ||
* Type '''F 39''' and press '''Enter'''. | * Type '''F 39''' and press '''Enter'''. | ||
* The spindle will now ramp up in speed over the course of 6 minutes. | * The spindle will now ramp up in speed over the course of 6 minutes. | ||
Latest revision as of 11:00, 3 February 2025
The spindle of this machine is a high-speed variety and must be warmed up before starting work. A warmup cycle is prompted when the machine is turned on, but should be performed again if it has sat unused for more than two hours.
Running a manual spindle warmup cycle
- Remove any tool that's in the spindle either manually using the release button or using the tool change function codes. The warmup cycle should not be run with a tool in the spindle.
- Clear the safety mat and turn the SAFETY RESET key.
- Type F 39 and press Enter.
- The spindle will now ramp up in speed over the course of 6 minutes.