Spindle Liners (Haas ST-15Y): Revision history

Diff selection: Mark the radio buttons of the revisions to compare and hit enter or the button at the bottom.
Legend: (cur) = difference with latest revision, (prev) = difference with preceding revision, m = minor edit.

12 December 2023

  • curprev 21:1721:17, 12 December 2023‎ Makerspace talk contribs‎ 615 bytes +615‎ Created page with "Category:Lathe Our lathe spindle has a bore size of 65mm - that is it can take an entire 65mm diameter bar through the spindle. To stop narrower bars from rattling around inside the spindle and causing damage there are a number of spindle liners that can be inserted to keep stock supported properly all the way along. '''Do not run the lathe with bar material protruding into the spindle without the appropriate liner installed. There is risk of serious damage to the..."
Retrieved from "https://www.makeinsalford.com/wiki/Spindle_Liners_(Haas_ST-15Y)"