Setting the Z-height (OMAX Maxiem 1515): Revision history

Diff selection: Mark the radio buttons of the revisions to compare and hit enter or the button at the bottom.
Legend: (cur) = difference with latest revision, (prev) = difference with preceding revision, m = minor edit.

2 December 2024

  • curprev 10:4610:46, 2 December 2024‎ A.Dunbar talk contribs‎ 2,652 bytes +15‎ No edit summary Tag: Visual edit
  • curprev 10:4110:41, 2 December 2024‎ A.Dunbar talk contribs‎ 2,637 bytes +2,637‎ Created page with "Setting the Z-height, or the distance from the tip of the nozzle to the material, is an important part of making accurate parts with the waterjet cutter. If the nozzle is too close you run the risk of blocking the nozzle and filling the abrasive hopper with water. If it's too far away, the accuracy of your parts will suffer. The process of setting the Z-height must be done each time the material is changed over, or if the material height changes significantly. === I..." Tag: Visual edit
Retrieved from "https://www.makeinsalford.com/wiki/Setting_the_Z-height_(OMAX_Maxiem_1515)"