View source for COSHH - Frost Equipment - Vibro Liquid

== Storage Location == 
[[:Category:COSHH Cabinet - Morson Engine Room|COSHH Cabinet - Morson Engine Room]]
    
Return this item to its storage place once you have finished using it. If it is empty, please let a member of technical staff know so more can be ordered.

== Manufacturer's Information ==

* [[Media:MSDS - Frost Vibro Liquid - C113.pdf|Material Safety Datasheet (MSDS)]]

== Personal Protective Equipment == 
{{PictogramExplanation|ppe-gloves|Nitrile Gloves|You must wear nitrile gloves when working with this liquid, whether in concentrate or diluted.}}
{{PictogramExplanation|ppe-safety-glasses|Safety Glasses|You must wear safety glasses when working with this liquid, whether in concentrate or diluted.}}

== Hazards ==
{{PictogramExplanation|hazard-general|Keep out of reach of children|}}
{{PictogramExplanation|hazard-corrosive|Causes serious eye damage|You must wear safety glasses when working with this liquid.}}
{{PictogramExplanation|hazard-irritant|Causes skin irritation|Wear nitrile gloves when working with this liquid or cleaning parts that have been tumbled using it.}}
{{PictogramExplanation|instruction-wash-hands|Wash Hands After Use|Wash your hands with soap and water after working with this liquid.}}

== Usage Information ==

* This fluid is used in the [[Frost Vibratory Tumbler|vibratory tumbler]] to enhance the performance of the tumbling media. 
* Vibro-liquid must be diluted before use - do not use the neat fluid from the small containers. There is a clearly labelled 5L jug of diluted fluid you can use in the Morson Engine Room COSHH cabinet. If the jug is empty, ask a member of staff to make up more solution.
* The working concentration of the diluted fluid is between 2% and 5%. In the 5L jug used to store the diluted fluid, 2% concentration is 100 ml, 5% concentration is 250 ml. Measure the concentrate in a clean glass beaker and add to the empty jug before topping off to 2 inches below the brim with cold tap water. 
* Parts in the tumbler should not be swimming in fluid - a small amount to loosen the abrasive media is all that is needed. Add fluid in small amounts - about 100 ml at a time - until the desired amount is present in the tumbler.
* The solution contains corrosion inhibitors so you don't need to worry about parts rusting while in the tumbler or immediately afterwards. 

== More Information ==
* [[:File:COSHH Label - Frost Equipment - Vibro Liquid.pdf|COSHH Label - Frost Equipment - Vibro Liquid.pdf]]
* [https://www.frost.co.uk/vibro-liquid-tumbler-solution/ Supplier page for re-ordering - Frost]

[[Category:COSHH - Chemicals]][[Category:COSHH Cabinet - Morson Engine Room]]