== Mould/former design ==
The Mayku website has [https://mayku.me/learn/template-design-creation a lot of information about designing template moulds and formers]
...
4 KB (579 words) - 10:49, 3 June 2024
...hem into other software. Adobe Illustrator, as software primarily used for design, likes to work in [[wikipedia:Point_(typography)|Points]] (defined as 1/72
This will cause problems with the size of your design - parts will come out approximately 1/3 of their intended size.
...
1 KB (204 words) - 12:47, 4 January 2024
...Epilog Dashboard software. In Dashboard it is possible to "break apart" a design to split it over several pieces of material if needed.
[[Category:Design]]
...
3 KB (566 words) - 17:17, 14 December 2023
...imited in most aspects of its use - including the expensive (but powerful) design and manufacturing extensions. It is most straightforward when using your Un
...
2 KB (257 words) - 16:47, 8 January 2024
The tailstock is a hybrid manual-hydraulic design. The body of the tailstock must be brought forward toward the chuck, and th
...
2 KB (345 words) - 17:59, 15 December 2023
'''Using Sketchup to design models for 3D printing is explicitly not recommended.'''
...ou want to print but want to learn the process, take a look at some of the design aggregator sites to find something that takes your interest. It's recommend
...
10 KB (1,727 words) - 16:35, 28 August 2024
...not reflect the surface that is actually sitting on the parallels. In the design workspace you can create a sketch on the correct plane (the base of the rou
...
3 KB (521 words) - 09:02, 21 February 2024
.... If you have to put excessive force into pressing your parts together the design should be adjusted, parts modified or a more powerful press (such as the fl
...
3 KB (509 words) - 17:49, 10 January 2024
...nt [[Hydraulic 3-Jaw Chuck|the 3-jaw chuck]]. The chuck is a "dead length" design, meaning that the amount of material sticking out of the face won't change
...
4 KB (762 words) - 18:19, 15 December 2023
...on. Press this to start the laser tracing the rectangular extremes of your design. This should automatically turn on the red dot pointer, but if it doesn't y
...
5 KB (840 words) - 10:52, 2 May 2024
...re Drilling (Haas ST-15Y)|with a centre]]) It is a hybrid manual-hydraulic design which needs adjustment for each job.
...
5 KB (775 words) - 10:56, 2 August 2024
|When your design is ready, left click on the '''Post''' button in the right hand toolbox.
...
7 KB (1,087 words) - 17:55, 28 August 2024
