New pages
- 11:00, 3 February 2025 Changing tools (AXYZ Innovator) (hist | edit) [889 bytes] A.Dunbar (talk | contribs) (Created page with "The AXYZ Innovator can automatically switch between three different tools, and also has the capability to use additional tools if they are swapped over by hand. == Picking up tools using the ATC == * Clear the safety mat and turn the '''SAFETY RESET''' key. * Type '''F 31.''n''''' and press '''Enter''', where '''''n''''' is the number of the tool you wish to pick up. For example, type F 31.1 to pick up the tool in ATC pocket one, F31.2 for pocket two, or F 31.3 for po...") Tag: Visual edit
- 10:48, 3 February 2025 Warming up the spindle (AXYZ Innovator) (hist | edit) [634 bytes] A.Dunbar (talk | contribs) (Created page with "The spindle of this machine is a high-speed variety and must be warmed up before starting work. A warmup cycle is prompted when the machine is turned on, but should be performed again if it has sat unused for more than an hour. == Running a manual spindle warmup cycle == * Remove any tool that's in the spindle either manually using the release button or using the tool change function codes. The warmup cycle should not be run with a tool in the spindle. * Clear the sa...") Tag: Visual edit
- 11:57, 20 January 2025 Probing tool length (AXYZ Innovator) (hist | edit) [1,553 bytes] A.Dunbar (talk | contribs) (Created page with "You must probe each of the tools every time you come to use the machine - do not assume that the tools in the rack have been set correctly. == Probing tool length automatically == * Turn on the machine and warm up the spindle. If the machine has been sat for more than an hour or two it's recommended you warm up the spindle again. * Remove the cover from the tool probe. * Clear the safety mat and turn the reset key. * Type '''F 25.''n''''' and press '''Enter''', where '...") Tag: Visual edit