639
edits
Work Offsets (Haas ST-15Y): Difference between revisions
no edit summary
No edit summary |
No edit summary |
||
| Line 25: | Line 25: | ||
* Type the negative key, then the diameter of the gauge pin, then press '''ENTER'''. This will subtract the diameter of the gauge pin from the Z offset, moving the origin back to the front face of the material. | * Type the negative key, then the diameter of the gauge pin, then press '''ENTER'''. This will subtract the diameter of the gauge pin from the Z offset, moving the origin back to the front face of the material. | ||
* You can make small adjustments to this offset in order to fine tune the length of parts or features. | * You can make small adjustments to this offset in order to fine tune the length of parts or features. | ||
[[Category:Lathe]] | |||