640
edits
Work Offsets (Haas ST-15Y): Difference between revisions
Created page with "== Methods for setting the Z offset == === Rough setting === This method is suitable for first operations only, where length accuracy is not a primary consideration. * Switch to a turning tool, such as T2. * Bring the tool close to the front face of the material, about a millimeter away from the face * The tool should be a few millimeters outside the OD of the stock to prevent colliding with the stationary material. * Slowly bring the tool towards the face of the stoc..."
(Created page with "== Methods for setting the Z offset == === Rough setting === This method is suitable for first operations only, where length accuracy is not a primary consideration. * Switch to a turning tool, such as T2. * Bring the tool close to the front face of the material, about a millimeter away from the face * The tool should be a few millimeters outside the OD of the stock to prevent colliding with the stationary material. * Slowly bring the tool towards the face of the stoc...") |
(No difference)
|