639
edits
Haas ST-15Y: Difference between revisions
→Usage information
| Line 22: | Line 22: | ||
=== [[Klamp DKF65A6|Workholding - Collets]] === | === [[Klamp DKF65A6|Workholding - Collets]] === | ||
The lathe usually has a collet chuck installed. This is an easy-to-use way to hold on to bar stock under 65mm in diameter. Check this page for how to change collets and order new sizes. | The lathe usually has a collet chuck installed. This is an easy-to-use way to hold on to bar stock under 65mm in diameter. Check this page for how to change collets and order new sizes. | ||
=== [[Hydraulic 3-Jaw Chuck|Workholding - Hydraulic 3-jaw chuck]] === | |||
If you wish to work with a part or stock larger than 65mm you will need to use the hydraulic three-jaw chuck. This uses three jaws to hold on to stock, and can have custom machined "soft jaws" fitted to ensure an exceptionally good fit on both raw stock and finished surfaces. | |||
=== [[Threading (Haas ST-15Y)|Threading]] === | === [[Threading (Haas ST-15Y)|Threading]] === | ||